https://linespeedjedi.com/exposing-a-spey-casting-myth-scandi-lines-single-spey

One huge misconception in spey casting is that you need to speed up into a low. flat high speed V loop to develop a high line speed spey Cast. There are 2 important components of a Healthy D loop. No Slack and Stress. No more power is needed in the sweep than to develop a tensioned D loop entirely devoid of slack. After a mild sweep where the rod pointer takes a trip in a slope course, (line follows the rod idea course) The lift should not be to high or low however moderate and sluggish, and the course of the rod idea ought to not dip down too quickly or the outcomes will be a crashed anchor

the start of the sweep should be sluggish and stay so throughout, and should definitely take a trip in a slope course after passing the castors position. The bottom leg of the D loop drifts down by method of gravity, providing the caster a lot of time to raise the elbows and get ready for the forward cast. As the anchor touches down gently the forward cast is used at simply the correct time. Leading early and the line will slip, blowing the anchor. If the forward cast is used too late the line will stick and excessive power will require to be used to the forward cast. A light, straight anchor, put somewhat forward of the caster not even more than a rod idea off to the side of the caster, need to produce simply enough grip on the water that the forward cast alone will pack the rod and produce high line speed. There is no requirement to subdue the sweep. An appropriately tensioned D loop that drifts down to the water’s surface area suffices to produce high linespeeds. Tight lines my buddies!